Home › ENGINE ยท 3ZR-FAE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CONNECT INTELLIGENT TESTER TO DLC3*

        HINT:
        If the display indicates a communication fault in the tester, inspect the DLC3.
        When any CAN communication system DTCs are output, perform troubleshooting for the CAN communication system first.


      NEXT


      4.CHECK DTC AND FREEZE FRAME DATA*

        HINT:
        If necessary, record or print DTCs and freeze frame data.
        1. Check the DTCs (Click here).
        2. Check the freeze frame data (Click here).


      NEXT


      5.CLEAR DTC AND FREEZE FRAME DATA*

        HINT:
        Refer to the relevant pages (Click here).


      NEXT


      6.CONDUCT VISUAL INSPECTION

        NEXT


        7.SET CHECK MODE DIAGNOSIS*

          NEXT


          8.CONFIRM PROBLEM SYMPTOMS

            HINT:
            If the engine does not start, first perform the Check for DTC procedures and Conduct Basic Inspection procedures below.

            Result 
            Result
            Proceed to
            Malfunction does not occur
            A
            Malfunction occurs
            B


          B.
          GO TO STEP 10
          A


          9.SIMULATE SYMPTOMS

            NEXT


            10.CHECK FOR DTC*

              HINT:
              Refer to the relevant pages (Click here).

              Result 
              Result
              Proceed to
              Trouble code output
              A
              No trouble code output
              B


            B.
            GO TO STEP 12
            A


            11.REFER TO DTC CHART

              HINT:
              Refer to the relevant pages (Click here).


            NEXT

            GO TO STEP 14


            12.CONDUCT BASIC INSPECTION
              Result 
              Result
              Proceed to
              Malfunctioning parts not confirmed
              A
              Malfunctioning parts confirmed
              B


            B.
            GO TO STEP 17
            A


            13.REFER TO PROBLEM SYMPTOMS TABLE
              Result 
              Result
              Proceed to
              Malfunctioning circuit confirmed
              A
              Malfunctioning parts confirmed
              B


            B.
            GO TO STEP 17
            A


            14.CHECK ECM POWER SOURCE CIRCUIT

              HINT:
              Refer to the relevant pages (Click here).


            NEXT


            15.CONDUCT CIRCUIT INSPECTION
              Result 
              Result
              Proceed to
              Malfunction not confirmed
              A
              Malfunction confirmed
              B


            B.
            GO TO STEP 18
            A


            16.CHECK FOR INTERMITTENT PROBLEMS

              NEXT

              GO TO STEP 18


              17.CONDUCT PARTS INSPECTION

                NEXT


                18.IDENTIFY PROBLEM

                  NEXT


                  19.ADJUST AND/OR REPAIR

                    NEXT


                    20.CONDUCT CONFIRMATION TEST

                      NEXT

                      END