Home › ENGINE ยท 3ZR-FAE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0116    Engine Coolant Temperature Circuit Range / Performance Problem

for Preparation Click here


DESCRIPTION

Refer to DTC P0115 .

DTC No.
DTC Detection Condition
Trouble Area
P0116
When either of the following conditions is met
(2 trip detection logic):
  1. When cold engine started and engine warmed up, engine coolant temperature sensor value does not change
  2. After warmed up engine stopped and then next cold engine start performed, engine coolant temperature sensor value does not change
  1. Thermostat
  2. Engine coolant temperature sensor
The engine coolant temperature is between -40 and 60°C (-40 and 140°F) when the engine is started, and conditions (a) and (b) are met (2 trip detection logic):
  1. (a) The vehicle is driven at varying speeds (accelerated and decelerated).
  2. (b) The engine coolant temperature remains within 3°C (5.4°F) of the initial engine coolant temperature.

INSPECTION PROCEDURE

HINT:
  1. If DTC P0115, P0117 or P0118 is output simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
  1. Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result 
    Result
    Proceed to
    DTC P0116 is output
    A
    DTC P0116 and other DTCs are output
    B

    HINT:
    If any DTCs other than P0116 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART (Click here)
A


2.INSPECT THERMOSTAT
  1. Remove the thermostat (Click here).

  1. Measure the valve opening temperature of the thermostat.

    Standard temperature:
    80°C to 84°C (176°F to 183°F)

    HINT:
    In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.

  1. Reinstall the thermostat (Click here).



NG
REPLACE THERMOSTAT (Click here)
OK

REPLACE ENGINE COOLANT TEMPERATURE SENSOR (Click here)