DTC P2119 Throttle Actuator Control Throttle Body Range / Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2119 | The throttle valve opening angle continues to vary greatly from the target opening angle (1 trip detection logic). |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (DTC P2119) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P2119 is output | A |
| DTC P2119 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT THROTTLE BODY (RESISTANCE OF THROTTLE ACTUATOR) |
Inspect the throttle body (Click here).
|
| ||||
| OK | |
| 3.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Clear the DTCs (Click here).
Allow the engine to idle for 15 seconds or more.
Fully depress and release the accelerator pedal several times quickly.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
|
| ||||
| OK | ||
| ||