Home › TRANSMISSION ยท K111F CVT › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM

CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.
  1. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.

      NEXT


      4.CONNECT INTELLIGENT TESTER TO DLC3*

        NEXT


        5.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
        1. Refer to DTC Check/Clear (Click here).


        NEXT


        6.VISUAL INSPECTION

          NEXT


          7.SETTING CHECK MODE DIAGNOSIS*
          1. Refer to Check Mode Procedure (Click here).


          NEXT


          8.PROBLEM SYMPTOM CONFIRMATION
          1. Refer to Road Test (Click here).
            Result 
            Result
            Proceed to
            Symptom does not occur
            A
            Symptom occurs
            B



          B.
          GO TO STEP 10
          A


          9.SYMPTOM SIMULATION
          1. Refer to Electronic Circuit Inspection Procedure (Click here).


          NEXT


          10.DTC CHECK*
          1. Refer to DTC Check/Clear (Click here).
            Result 
            Result
            Proceed to
            DTC not output
            A
            DTC output
            B



          B.
          GO TO STEP 16
          A


          11.BASIC INSPECTION
          1. Refer to Continuously Variable Transaxle Fluid (Click here).

          2. Refer to Park/Neutral Position Switch (Click here).

          3. Refer to Shift Lever (Click here).



          NG.
          GO TO STEP 19
          OK


          12.MECHANICAL SYSTEM TEST*
          1. Refer to Mechanical System Test (Click here).



          NG.
          GO TO STEP 15
          OK


          13.HYDRAULIC TEST*
          1. Refer to Hydraulic Test (Click here).



          NG.
          GO TO STEP 15
          OK


          14.PROBLEM SYMPTOMS TABLE
          1. Refer to Problem Symptoms Table (Click here).



          NG.
          GO TO STEP 17
          OK


          15.COMPONENT INSPECTION


            NG.
            GO TO STEP 19
            OK


            16.DTC CHART
            1. Refer to Diagnostic Trouble Code Chart (Click here).


            NEXT


            17.CIRCUIT INSPECTION

              NEXT


              18.IDENTIFICATION OF PROBLEM

                NEXT


                19.REPAIR OR REPLACE

                  NEXT


                  20.CONFIRMATION TEST

                    NEXT

                    END