DTC P0013 Camshaft Position "B" Actuator Circuit / Open (Bank 1) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0013 | An open or short in the camshaft timing oil control valve for the exhaust camshaft circuit (1 trip detection logic). |
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OPERATE CAMSHAFT TIMING OIL CONTROL VALVE) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Exhaust Linear (Bank 1).
Check the engine speed when the oil control valve is operated using the intelligent tester when the engine coolant temperature is 50°C (122°F) or less.
| Tester Operation | Specified Condition |
| -128% (Oil control valve OFF) | Normal engine speed |
| 127% (Oil control valve ON) | Engine idles roughly or stalls (soon after oil control valve switched from OFF to ON) |
|
| ||||
| OK | ||
| ||
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
![]() |
Remove the camshaft timing oil control valve assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 6.9 to 7.9 Ω |
| *1 | Component without harness connected (Camshaft Timing Oil Control Valve) |
![]() |
Apply positive (+) battery voltage to terminal 1 and negative (-) battery voltage to terminal 2. Check the valve operation.
Reinstall the camshaft timing oil control valve assembly.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY - ECM) |
![]() |
Disconnect the camshaft timing oil control valve assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B115-1 - B32-75 (OE1+) | Always | Below 1 Ω |
| B115-2 - B32-97 (OE1-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| B115-1 or B32-75 (OE1+) - Body ground | Always | 10 kΩ or higher |
| B115-2 or B32-97 (OE1-) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Camshaft Timing Oil Control Valve) |
| *2 | Front view of wire harness connector (to ECM) |
Reconnect the camshaft timing oil control valve assembly connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||