DTC C1210 Zero Point Calibration of Yaw Rate Sensor Undone |
DTC C1336 Zero Point Calibration of Acceleration Sensor Undone |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1210 | Zero point calibration of yaw rate sensor undone. | Yaw rate and deceleration sensor |
| C1336 | Zero point calibration of acceleration sensor undone. | Yaw rate and deceleration sensor |
| 1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR |
Perform zero point calibration of the yaw rate and deceleration sensor (Click here).
| NEXT | |
| 2.PERFORM TEST MODE (SIGNAL CHECK) |
Turn the ignition switch off.
Perform the sensor check in the Test Mode procedure (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and deceleration sensor has been installed properly .
|
| ||||
| OK | |
| 4.READ VALUE USING INTELLIGENT TESTER (YAW RATE AND DECELERATION SENSOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Deceleration Sensor | Deceleration sensor 1 reading / min.: -18.52 m/s2, max.: 18.39 m/s2
| Min.: -18.52 m/s2
Max.: 18.39 m/s2 | Reading changes when vehicle is bounced |
| Deceleration Sensor 2 | Deceleration sensor 2 reading / min.: -18.52 m/s2, max.: 18.39 m/s2
| Min.: -18.52 m/s2
Max.: 18.39 m/s2 | Reading changes when vehicle is bounced |
| Yaw Rate Sensor | Yaw rate sensor 1 reading / min.: -128 deg/s, max.: 127 deg/s | Vehicle stationary: 0 deg/s Right turn: -128 to 0 deg/s Left turn: 0 to 127 deg/s | - |
Check that the yaw rate and deceleration sensor output value displayed on the intelligent tester.
|
| ||||
| OK | ||
| ||