DTC C1429 Open or Short in Brake Pedal Load Sensing Switch |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1429 | An open or short in the brake pedal load sensing switch continues for 0.3 seconds or more. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (BRAKE PEDAL LOAD SENSING SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Brake Pedal Load Sensing SW | Brake pedal load sensing switch / ON or OFF | ON: Brake pedal depressed beyond the specified point OFF: Brake pedal not depressed beyond the specified point | - |
Check that the brake pedal load sensing switch display observed on the intelligent tester changes according to brake pedal operation.
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Perform the road and braking test.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC (C1429) is not output. | A |
| DTC (C1429) is output. | B |
|
| ||||
| A | ||
| ||
| 3.INSPECT BRAKE PEDAL LOAD SENSING SWITCH |

Turn the ignition switch off.
Make sure that there is no looseness in the locking part and connecting part of the connector.
Disconnect the brake pedal load sensing switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Brake pedal load sensing switch off (Brake pedal depressed) | 0.9 to 1.1 kΩ |
| Brake pedal load sensing switch on (Brake pedal released) | 192 to 234 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE PEDAL LOAD SENSING SWITCH) |
![]() |
Make sure that there is no looseness in the locking part and connecting part of the connector.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A67-27 (FSW+) - A3-2 | Always | Below 1 Ω |
| A67-27 (FSW+) - Body ground | Always | 10 kΩ or higher |
| A3-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||