AUDIO AND VISUAL SYSTEM > Illumination Circuit |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the E90 receiver connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E90-7 (GND) - Body ground | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E90-10 (ILL+) - Body ground | Light control switch off | Below 1 V |
| E90-10 (ILL+) - Body ground | Light control switch TAIL or HEAD | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK VEHICLE EQUIPMENT |
Check if the steering pad switch is equipped on the vehicle.
| Result | Proceed to |
| w/ Steering pad switch | A |
| w/o Steering pad switch | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE - RADIO RECEIVER) |
![]() |
Disconnect the E10 spiral cable connector.
Disconnect the E92*1 or E107*2 radio receiver connector.
*1: except Europe
*2: for Europe
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E10-4 (EAU) - E92-6 (SWG) | Below 1 Ω |
| Tester Connection | Specified Condition |
| E10-4 (EAU) - E107-6 (SWG) | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E10-12 (IL+2) - Body ground | Light control switch TAIL or HEAD | 11 to 14 V |
|
| ||||
| OK | |
| 4.INSPECT STEERING PAD SWITCH ASSEMBLY |
Remove the steering pad switch (Click here).

Connect the positive (+) lead of the battery to terminal 5 (IL+2) and the negative (-) lead to terminal 8 (EAU) of the switch connector.
Check if the illumination for the switch comes on.
|
| ||||
| OK | |
| 5.INSPECT SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Remove the spiral cable (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4 (EAU) - 8 (EAU) | Spiral cable is turned 2.5 rotations counterclockwise | Below 1 Ω |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise | ||
| 12 (IL+2) - 5 (IL+2) | Spiral cable is turned 2.5 rotations counterclockwise | Below 1 Ω |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise |
|
| ||||
| OK | ||
| ||