Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › CONDENSER

CONDENSER > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



3. REMOVE FRONT BUMPER COVER
  1. w/ Under Guard:
    Remove front bumper cover (Click here).

  1. w/o Under Guard:
    Remove front bumper cover (Click here).

  1. w/ Hood Moulding:
    Remove front bumper cover (Click here).



4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    H102042
  1. Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler condenser.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



5. DISCONNECT LIQUID PIPE SUB-ASSEMBLY


    H102043
  1. Remove the bolt and disconnect the liquid pipe sub-assembly from the cooler condenser.

  1. Remove the O-ring from the liquid pipe sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



6. REMOVE UPPER RADIATOR SUPPORT


    E126555
  1. Remove the 2 bolts and 2 brackets.



7. REMOVE NO. 2 FAN SHROUD


E126556
  1. Remove the 2 bolts and fan shroud.



8. REMOVE COOLER CONDENSER ASSEMBLY


    B135838
  1. Remove the cooler condenser.



9. REMOVE COOLER DRYER


    I030086E01
  1. Using a 14 mm socket hexagon wrench, remove the cap from the modulator.



    I032475E01
  1. Remove the O-ring from the cap.



    E050386E01
  1. Using pliers, remove the cooler dryer.