DTC P0793 Intermediate Shaft Speed Sensor "A" |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0793 | ECM detects conditions (a), (b) and (c) continuously for 5 sec. or more (1 trip detection logic): (a) Vehicle speed: 50 km/h (31 mph) or more (b) Park/Neutral position switch NSW is OFF (c) Speed sensor NC: Less than 300 rpm |
|

| Tester Display | Measurement Item/ Range | Normal Condition | Diagnostic Note |
| SPD (NC) | Counter gear speed/ Min.: 0 rpm Max.: 12,750 rpm | 3rd gear when shift lever is on D (after warming up the engine); Intermediate shaft speed (NC) becomes close to the engine speed | Data is displayed in increments of 50 rpm |
| 1.INSPECT SPEED SENSOR (INSTALLATION) |
![]() |
Check the speed sensor NC installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR NC |
![]() |
Disconnect the speed sensor connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR - ECM) |
![]() |
Connect the speed sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B96-4 (NC+) - B96-3 (NC-) | 20°C (68°F) | 560 to 680 Ω |
| B96-4 (NC+) - Body ground | Always | 10 kΩ or higher |
| B96-3 (NC-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||