DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve DSL) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0741 | Lock-up does not occur when driving in the lock-up range (normal driving at 80 km/h [50 mph]), or lock up remains ON in the lock-up OFF range (2 trip detection logic) |
|

| Tester Display | Test Part | Control Range | Diagnostic Note |
| Activate the Lock Up | [Test Details] Control shift solenoid DSL to set automatic transaxle to the lock-up condition [Vehicle Condition]
| ON/OFF | Possible to check shift solenoid valve DSL operation |

| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0741) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the tester.
| Result | Proceed to |
| P0741 | A |
| P0741 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE DSL) |
![]() |
Disconnect the transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 10 (DSL) - Body ground | 20°C (68°F) | 11 to 13 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() |
Connect the transmission wire connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B96-9 (DSL) - Body ground | 20°C (68°F) | 11 to 13 Ω |
|
| ||||
| OK | ||
| ||
| 4.INSPECT SHIFT SOLENOID VALVE DSL |
![]() |
Remove the shift solenoid valve DSL.
Measure the resistance between the solenoid valve terminal and solenoid valve body.
| Tester Connection | Condition | Specified Condition |
| Solenoid Connector (DSL) - Solenoid Body (DSL) | 20°C (68°F) | 11 to 13 Ω |
Connect the battery's positive (+) lead to the terminal of the solenoid valve connector, and the negative (-) lead to the solenoid body. Then check that the valve moves and makes an operating sound.
|
| ||||
| OK | |
| 5.CHECK TRANSMISSION WIRE |
|
| ||||
| OK | |
| 6.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly.
|
| ||||
| OK | |
| 7.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Check the torque converter clutch assembly (Click here).
|
| ||||
| OK | ||
| ||