DTC C1251/51 Open in Pump Motor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1251/51 | When either condition below is met:
|
|
| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY) |
Select the Active Test, generate a control command, and then check that the ABS motor relay operates.
| Tester Display | Test Parts | Control Range | Diagnosis Note |
| Motor Relay | Turn ABS motor relay | ON or OFF | Operation sound of motor can be heard |
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at a speed of 6 km/h (4 mph) or more for several seconds.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||
| 3.INSPECT FUSE (ABS1) |
Remove the ABS1 fuse from the engine room No. 1 relay block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A27 ECU connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| A27-2 (GND1) - Body ground | Below 1 Ω |
| A27-24 (GND2) - Body ground | Below 1 Ω |
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| A27-23 (+BM) - Body ground | 11 to 14 V |
|
| ||||
| OK | ||
| ||