BRAKE MASTER CYLINDER (for LHD) > REMOVAL |
| 1. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 1AZ-FE) |
Remove the air cleaner case (Click here).
| 2. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2AZ-FE) |
Remove the air cleaner case (Click here).
| 3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 3ZR-FAE) |
Remove the air cleaner case (Click here).
| 4. DRAIN BRAKE FLUID |
| 5. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
![]() |
Release the vacuum pressure in the brake booster as follows.
Stop the engine.
Depress the brake pedal several times.
for Manual Transaxle:
Disconnect the clutch reservoir tube labeled A from the master cylinder.
Disconnect the brake fluid level warning switch connector labeled B.
Using a union nut wrench, disconnect the 2 brake lines labeled C from the master cylinder.
Remove the 2 nuts.
![]() |
Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.