Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

DTC    C1249/49    Open in Stop Light Switch Circuit

for Preparation Click here


DESCRIPTION

The skid control ECU detects the brake operating conditions through a signal transmitted by the stop light switch. The skid control ECU incorporates an open circuit detection circuit. This DTC is set under either of the following conditions:
  1. An open is detected in the stop light signal input line when the stop light switch is off.
  2. An open is detected in the stop light circuit lead to the ground when the stop light switch is off.

DTC No.
DTC Detection Condition
Trouble Area
C1249/49
When IG1 terminal voltage is 9.5 to 18.5 V, open circuit of stop light switch continues for 3 seconds or more.
  1. STOP fuse
  2. Stop light switch
  3. Stop light switch circuit
  4. Stop light control relay circuit
  5. Brake actuator (Skid control ECU)

WIRING DIAGRAM


C196899E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuse for circuits related to this system before performing the following inspection procedure.

1.CHECK STOP LIGHT OPERATION
  1. Check that the stop lights come on when the brake pedal is depressed, and go off when the brake pedal is released.

    OK:
    Condition
    Illumination Condition
    Brake pedal depressed
    ON
    Brake pedal released
    OFF



NG
Go to step 4
OK


2.CHECK HARNESS AND CONNECTOR (STP VOLTAGE)


    C117862E56
  1. Disconnect the A27 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A27-10 (STP) - Body ground
    Brake pedal depressed
    8 to 14 V
    A27-10 (STP) - Body ground
    Brake pedal released
    Below 1.5 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

4.INSPECT STOP LIGHT SWITCH ASSEMBLY


    C194435E01
  1. Remove the stop light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pin not pushed
    Below 1 Ω
    Pin pushed
    10 kΩ or higher
    3 - 4
    Pin not pushed
    10 kΩ or higher
    Pin pushed
    Below 1 Ω



NG
REPLACE STOP LIGHT SWITCH ASSEMBLY (Click here)
OK

GO TO LIGHTING SYSTEM (STOP LIGHT SWITCH CIRCUIT) (Click here)