VEHICLE STABILITY CONTROL SYSTEM > Skid Control Buzzer Circuit |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BUZZER) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Active Test mode on the intelligent tester (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Buzzer | Skid control buzzer | Buzzer ON / OFF | Buzzer can be heard. |
|
| ||||
| NG | |
| 3.INSPECT COMBINATION METER ASSEMBLY |
Inspect the combination meter (Click here).
|
| ||||
| OK | ||
| ||