Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

DTC    B2799    Engine Immobiliser System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the ID code box; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the ID code box and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no certification ECU DTCs are present. If present, troubleshoot the certification ECU DTCs first.

DTC Code
DTC Detection Condition
Trouble Area
B2799
One of following conditions is met:
  1. Error in communication between ECM and ID code box
  2. Error in communication lines
  3. Communication ID is different during communication with ID code box
  1. Wire harness
  2. ID code box
  3. ECM

WIRING DIAGRAM


B121684E09


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Recheck for the DTC.

    OK:
    B2799 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK WIRE HARNESS (ID CODE BOX - ECM)
E180658E05
  1. Disconnect the E51 box connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness connectors.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E51-5 (EFII) - A12-10 (IMO)
    Always
    Below 1 Ω
    E51-6 (EFIO) - A12-11 (IMI)
    E51-5 (EFII) or A12-10 (IMO) - Body ground
    Always
    10 kΩ or higher
    E51-6 (EFIO) or A12-11 (IMI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REREGISTER ECU CODE REGISTRATION
  1. Clear the DTC (Click here).

  1. Reregister the ID code box and ECM communication ID.

  1. Check that the engine starts.

    OK:
    Engine starts.



NG
END (PROBLEM HAS BEEN CAUSED BY REGISTRATION FAILURE)
OK


4.CHECK ID CODE BOX (OPERATION)
  1. Temporarily replace the ID code box with a new one.

  1. Check that the engine starts.

    OK:
    Engine starts.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1AZ-FE)
    B
    NG (for 2AZ-FE)
    C
    NG (for 3ZR-FAE)
    D



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A

END (ID CODE BOX IS DEFECTIVE)