VEHICLE STABILITY CONTROL SYSTEM > Downhill Assist Control Indicator Light Remains ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.CHECK SKID CONTROL ECU CONNECTOR |
Check if the skid control ECU connector is securely connected.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND) |
![]() |
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A67-29 (HDCS) - Body ground | Downhill assist control switch is pushed | Below 1 Ω |
| Downhill assist control switch is not pushed | 10 kΩ or higher |
|
| ||||
| NG | |
| 4.INSPECT DOWNHILL ASSIST CONTROL SWITCH |
![]() |
Remove the downhill assist control switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 4 | Switch is pushed | Below 1 Ω |
| Switch is not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (DOWNHILL ASSIST CONTROL SW - SKID CONTROL ECU/BODY GROUND) |
![]() |
Disconnect the skid control ECU connector.
Disconnect the downhill assist control switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A67-29 (HDCS) - E36-4 | Always | Below 1 Ω |
| A67-29 (HDCS) - Body ground | Always | 10 kΩ or higher |
| E36-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 6.INSPECT COMBINATION METER ASSEMBLY |
Inspect the combination meter (Click here).
|
| ||||
| OK | ||
| ||