REAR SPEED SENSOR (for 4WD) > INSTALLATION |
| 1. INSTALL REAR SPEED SENSOR LH |
![]() |
Install the sensor (labeled A) with the bolt (labeled B).
Install the sensor clamp (labeled C) with the nut (labeled D).
![]() |
Install the sensor clamps (labeled E) with the 2 nuts (labeled F).
Install the sensor clamp (labeled G) with the bolt (labeled H).
![]() |
Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel house.
![]() |
Hold the grommet and pull it from the inside of the vehicle to the outside of the vehicle. Then fix it in place so that it is not tilted.
![]() |
Connect the speed sensor connector.
| 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH |
for Short Body:
Install the deck trim side panel LH (Click here).
for Long Body:
Install the deck trim side panel LH (Click here).
| 3. INSTALL REAR WHEEL |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. CHECK SPEED SENSOR SIGNAL |
w/o VSC:
Check the speed sensor signal (Click here).
w/ VSC:
Check the speed sensor signal (Click here).