Home › BRAKE › BRAKE CONTROL › SKID CONTROL SENSOR (for 2WD)

SKID CONTROL SENSOR (for 2WD) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)
  1. Install the rear axle hub and bearing LH (Click here).



2. INSTALL REAR DISC


    C127291E01
  1. Align the matchmarks and install the disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the smallest runout.



3. INSTALL REAR DISC BRAKE CYLINDER MOUNTING LH


    C127287
  1. Install the cylinder mounting with the 2 bolts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }



4. INSTALL SKID CONTROL SENSOR WIRE

NOTICE:
To prevent interference with other parts, do not twist the painted line areas of the sensor wire when installing it.



    C127966E02
  1. Connect the skid control sensor wire connector (labeled A) to the skid control sensor.

  1. Install the sensor clamp (labeled B) with the bolt (labeled C).

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    Do not twist the sensor wire when installing the clamp.



    C127967E02
  1. Install the sensor clamps (labeled D) with the 2 nuts (labeled E).

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    NOTICE:
    Do not twist the sensor wire when installing the clamps.

  1. Install the sensor clamp (labeled F) with the bolt (labeled G).

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    Do not twist the sensor wire when installing the clamp.



    C127968E01
  1. Insert the connector and grommet into the inside of the vehicle through the passage hole in the wheel house.

    NOTICE:
    Make sure the grommet band clamp remains on the outside of the vehicle.



    C127969E01
  1. Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.

    NOTICE:
    1. When pulling out the grommet, do not grip the sensor wire.
    2. Fix the grommet in place within the range shown in the illustration.



    C127328
  1. Connect the skid control sensor wire connector.



5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
  1. Install the deck trim side panel LH (Click here).

    HINT:
    Refer to the procedures from the installation of the deck trim side panel LH up until the installation of the rear door scuff plate LH.



6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


8. CHECK SPEED SENSOR SIGNAL
  1. w/o VSC:
    Check the speed sensor signal (Click here).

  1. w/ VSC:
    Check the speed sensor signal (Click here).