FRONT AXLE HUB > INSTALLATION |
| 1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH |
![]() |
Install the dust cover to the steering knuckle.
Install the axle hub with the 4 bolts.
| 2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH |
Install the front lower ball joint assembly with the nut to the steering knuckle.
Install a new clip.
| 3. INSTALL STEERING KNUCKLE WITH AXLE HUB |
Align the shaft splines and drive in the drive shaft.
Install the steering knuckle with axle hub with the 2 bolts and 2 nuts.
| 4. CONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH |
Connect the lower arm to the ball joint with the 2 bolts and nut.
| 5. CONNECT TIE ROD END SUB-ASSEMBLY LH |
![]() |
Connect the tie rod end to the steering knuckle with the castle nut.
Install a new cotter pin.
| 6. INSTALL FRONT SPEED SENSOR LH |
![]() |
Set the sensor into the knuckle, and then install the sensor with the bolt.
Install the sensor clamp and sensor clip as follows.

Simultaneously perform the following: 1) hang the hook part of the sensor clamp (labeled A) on the part of the flexible hose bracket (labeled C); and 2) insert the hook part of the sensor clamp (labeled B) to the part of the flexible hose bracket (labeled D).
Install the sensor clamp to the flexible hose clamp and flexible hose bracket with the bolt (labeled E).
Insert the sensor clip (labeled F) into the hole on the absorber lower bracket.
![]() |
Install the sensor clamp and sensor clip as follows.
Set the sensor clamp (labeled G) on the side member, and then install the bolt (labeled H).
Insert the sensor clip (labeled I) into the hole on the apron.
![]() |
Connect the sensor connector.
| 7. CHECK FRONT AXLE HUB BEARING |
Check the axle hub bearing .
| 8. INSTALL FRONT DISC |
![]() |
Put matchmarks on the disc and axle hub.
Remove the disc.
| 9. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH |
![]() |
Install the cylinder with the 2 bolts.
| 10. INSTALL FRONT AXLE SHAFT NUT LH |
Clean the threaded parts on the drive shaft and a new axle shaft nut using a non-residue solvent.
Install a new shaft nut.
![]() |
Using a chisel and hammer, stake the shaft nut.
| 11. INSTALL FRONT WHEEL |
| 12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
Inspect and adjust the wheel alignment (Click here).
| 13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 14. CHECK SPEED SENSOR SIGNAL |
Check the speed sensor signal for ABS (Click here).
Check the speed sensor signal for VSC (Click here).