VEHICLE STABILITY CONTROL SYSTEM > AUTO LSD Indicator Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (AUTO LSD SWITCH) |
Check the Data List for proper functioning of the AUTO LSD switch (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Auto LSD Switch | Traction control switch (VSC OFF switch) / ON or OFF | ON: VSC OFF switch is on OFF: VSC OFF switch is off | - |
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (AUTO LSD INDICATOR LIGHT) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Active Test mode on the intelligent tester (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Auto LSD Indicator Light | AUTO LSD indicator light | Indicator light ON / OFF | Observe the combination meter. |
|
| ||||
| OK | |
| 4.INSPECT COMBINATION METER ASSEMBLY |
Inspect the combination meter (Click here).
|
| ||||
| OK | ||
| ||
| 5.INSPECT TRACTION CONTROL SWITCH (VSC OFF SWITCH) |
![]() |
Remove the VSC OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 (E) - 9 (+) | Not pushed | 10 kΩ or higher |
| Pushed | Below 1Ω |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (VSC OFF SWITCH - SKID CONTROL ECU/BODY GROUND) |
![]() |
Disconnect the skid control ECU connector.
Disconnect the VSC OFF switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A67-30 (CSW) - E96-9 (+) | Always | Below 1 Ω |
| A67-30 (CSW) - Body ground | Always | 10 kΩ or higher |
| E96-6 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||