REAR CRANKSHAFT OIL SEAL > REMOVAL |
| 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
Remove the engine assembly with transaxle (Click here).
| 2. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle) |
for 2WD:
Remove the manual transaxle assembly (Click here).
for 4WD:
Remove the manual transaxle assembly (Click here).
| 3. REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY (for CVT) |
Remove the continuously variable transaxle assembly (Click here).
| 4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle) |
![]() |
Put matchmarks on the clutch cover assembly and flywheel sub-assembly.
| *1 | Matchmark |
Loosen each set bolt one turn at a time in the order shown in the illustration until the spring tension is released.
Remove the set bolts and pull off the clutch cover assembly.
| 5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle) |
| 6. REMOVE ORIFICE TO FLEXIBLE HOSE TUBE (for Manual Transaxle) |
![]() |
Using a union nut wrench, separate the orifice to flexible hose tube from the clutch orifice assembly.
Remove the bolt and orifice to flexible hose tube.
| 7. REMOVE CLUTCH RELEASE CYLINDER TO ACCUMULATOR TUBE (for Manual Transaxle) |
![]() |
Using a union nut wrench, remove the clutch release cylinder to accumulator tube.
| 8. REMOVE CLUTCH ORIFICE ASSEMBLY (for Manual Transaxle) |
![]() |
Remove the 2 bolts and clutch orifice assembly.
| 9. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY (for Manual Transaxle) |
![]() |
Using a union nut wrench, separate the clutch release bleeder sub-assembly from the clutch release cylinder to bleeder tube.
Remove the 2 bolts and clutch release bleeder sub-assembly from the manual transaxle assembly.
| 10. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY (for Manual Transaxle) |
![]() |
Remove the clutch tube boot from the manual transaxle assembly.
![]() |
Remove the 3 bolts and clutch release with bearing cylinder assembly and clutch release cylinder to bleeder tube.
![]() |
Using a union nut wrench, remove the clutch release cylinder to bleeder tube from the clutch release with bearing cylinder assembly.
| 11. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle) |
![]() |
Using SST, hold the crankshaft.
![]() |
Remove the 8 bolts and flywheel.
| 12. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for CVT) |
![]() |
Using SST, hold the crankshaft.
![]() |
Remove the 8 bolts, rear spacer, drive plate and front spacer.
| 13. REMOVE ENGINE REAR OIL SEAL |
![]() |
Using a knife, cut off the lip of the oil seal.
| *1 | Cut Position |
| *2 | Protective Tape |
Using a screwdriver with its tip wrapped with tape, pry out the oil seal.