Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

DTC    C1241/41    Low Battery Positive Voltage

for Preparation Click here


DESCRIPTION

When there is an abnormality in the power supply circuit of the brake actuator (skid control ECU), the skid control ECU sets a DTC and the operation is prohibited by the fail-safe function. This DTC is set when the voltage supplied to terminal IG1 is outside the DTC detection threshold, due to abnormalities of the battery, power source circuits or charging circuits, such as the alternator circuit.
The fail-safe function is canceled when the voltage to terminal IG1 returns to normal.

DTC No.
DTC Detection Condition
Trouble Area
C1241/41
When one of following conditions is met:
  1. At vehicle speed of 3 km/h (2 mph) or more, IG1 terminal voltage is 9.5 V or less for 10 seconds or more.
  2. When solenoid relay remains ON and IG1 terminal voltage is 9.5 V or less, relay contact open for 0.2 seconds or more.
  3. When motor relay remains ON and IG1 terminal voltage becomes 9.5 V or less, actuator pump motor is OFF for 0.1 seconds or more.
  4. When IG1 terminal voltage is 9.5 V or less, vehicle speed sensor power supply decreases for 60 seconds or more.
  1. Battery
  2. Charging system
  3. Power source circuit
  4. Internal power supply circuit of skid control ECU

WIRING DIAGRAM


C206202E01


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-IG1)
  1. Remove the ECU-IG1 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.INSPECT BATTERY
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V



NG
CHECK CHARGING SYSTEM
OK


3.CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY)


    C117862E08
  1. Disconnect the A27 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A27-25 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (SKID CONTROL ECU - BODY GROUND)


    C117862E09
  1. Disconnect the A27 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A27-2 (GND1) - Body ground
    Below 1 Ω
    A27-24 (GND2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Drive the vehicle at 3 km/h (2 mph) or more for several seconds.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)