DTC C1379 Downhill Assist Control Switch Malfunction (Test Mode DTC) |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1379 | Stored only during Test Mode. | Downhill assist control switch |

| 1.READ VALUE USING INTELLIGENT TESTER (DOWNHILL ASSIST CONTROL SWITCH) |
Check the Data List for proper functioning of the downhill assist control switch.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Downhill Assist Control Switch | Downhill assist control switch / ON or OFF | ON: Downhill assist control switch is on OFF: Downhill assist control switch is off | - |
|
| ||||
| OK | |
| 2.PERFORM TEST MODE (SIGNAL CHECK) |
Turn the ignition switch off.
Perform the sensor check in the Test Mode procedure (Click here).
|
| ||||
| OK | ||
| ||
| 3.INSPECT DOWNHILL ASSIST CONTROL SWITCH |
![]() |
Turn the ignition switch off.
Make sure that there is no looseness in the locking part and connecting part of the connector.
Disconnect the downhill assist control switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 4 | Switch is pushed | Below 1 Ω |
| Switch is not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (DOWNHILL ASSIST CONTROL SW - SKID CONTROL ECU/BODY GROUND) |
![]() |
Disconnect the skid control ECU connector.
Disconnect the downhill assist control switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A67-29 (HDCS) - E36-4 | Always | Below 1 Ω |
| A67-29 (HDCS) - Body ground | Always | 10 kΩ or higher |
| E36-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||