Home › TRANSMISSION ยท K111F CVT › DIFFERENTIAL OIL SEAL (for LH Side)

DIFFERENTIAL OIL SEAL (for LH Side) > REPLACEMENT

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A206200
  1. Remove the 6 screws, 10 clips and under cover.



2. REMOVE REAR ENGINE UNDER COVER LH


    A196893
  1. Remove the 2 clips and under cover.



3. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID


    C242832
  1. Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the continuously variable transaxle assembly.



    C242875E01
  1. Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the continuously variable transaxle assembly and drain the continuously variable transaxle fluid.
    Text in Illustration 
    *1
    No. 1 Transmission Oil Filler Tube

  1. Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the continuously variable transaxle assembly.

    Torque:
    1.7 N*m{ 17 kgf*cm , 15 in.*lbf }

  1. Temporarily install the gasket and overflow plug.

    HINT:
    Reuse the old gasket. The plug will be removed again to adjust the fluid level.



4. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
  1. Remove the front drive shaft LH (Click here).



5. REMOVE CVT TYPE T OIL SEAL LH


C103977E02
  1. Using SST, tap out the oil seal from the transaxle case.

    SST
    09308-00010  

    NOTICE:
    Do not damage the transaxle case.



6. INSTALL CVT TYPE T OIL SEAL LH


C130647E02
  1. Using SST and a hammer, tap in a new oil seal to the transaxle case.

    SST
    09726-27012   (09726-02041)
    09950-70010   (09951-07200)

    Standard depth:
    -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

    NOTICE:
    Do not damage the lip of the oil seal.

  1. Coat the lip of the oil seal with MP grease.



7. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
  1. Install the front drive shaft LH (Click here).



8. ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID
  1. Add continuously variable transaxle fluid (Click here).



9. INSTALL REAR ENGINE UNDER COVER LH


    A196893
  1. Install the under cover with the 2 clips.



10. INSTALL NO. 1 ENGINE UNDER COVER


    A206200
  1. Install the under cover with the 6 screws and 10 clips.