Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1417    High Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS/VSC/TRC operation.
This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or alternator circuit, etc.
This DTC is canceled when the IG1 terminal voltage returns to normal.

DTC Code
DTC Detection Condition
Trouble Area
C1417
The IG1 terminal voltage is 17.4 V or higher for 1 second or more.
  1. ECU-IG1 fuse
  2. Battery
  3. Charging system
  4. Power source circuit
  5. Internal power supply circuit of the skid control ECU

WIRING DIAGRAM

Refer to DTC C1241 .

INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK BATTERY
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V

    Result:
    Result
    Proceed to
    OK
    A
    NG
    for 1AZ-FE
    B
    for 2AZ-FE
    C
    for 2GR-FE
    D
    for 3ZR-FAE
    E



B
CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (Click here)

C
CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (Click here)

D
CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (Click here)

E
CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (Click here)
A


2.INSPECT SKID CONTROL ECU (IG1 TERMINAL)


    C194130E18
  1. Make sure that there is no looseness in the locking part and connecting part of the connectors.

  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A67-34 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)