Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION ANTENNA

NAVIGATION ANTENNA > INSTALLATION

for Preparation Click here



1. INSTALL NAVIGATION ANTENNA ASSEMBLY


    E125791
  1. Install the navigation antenna with the 2 screws.



2. INSTALL NO. 3 HEATER TO REGISTER DUCT


    B208595
  1. Install the duct with the 2 screws.



3. INSTALL NO. 2 HEATER TO REGISTER DUCT


    B208594
  1. Install the duct with the screw.



4. INSTALL NO. 1 HEATER TO REGISTER DUCT


    B208593
  1. Install the duct with the screw.



5. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT


    B208592
  1. Install the duct with the 3 screws.



6. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT


    B208591
  1. Install the duct with the 3 screws.



7. INSTALL UPPER INSTRUMENT PANEL
  1. Attach the 6 clips and 5 claws to install the instrument panel.

  1. Connect the connector and attach the clamp.

  1. Install the 2 bolts and 2 screws.



  1. Connect the passenger airbag connector.


    B208364



    B129886
  1. Install the 2 bolts to the passenger airbag.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



8. INSTALL FRONT PILLAR GARNISH RH
  1. for Short Body:
    Install the front pillar garnish .

  1. for Long Body:
    Install the front pillar garnish .



9. INSTALL FRONT PILLAR GARNISH LH
  1. for Short Body:
    Install the front pillar garnish .

  1. for Long Body:
    Install the front pillar garnish .



10. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    B129887
  1. Attach the 2 hinges to install the door.



    B129889E03
  1. Attach the claw to the glove compartment door stopper.

  1. While pushing in the sides of the glove compartment door in the direction indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.



11. INSTALL INSTRUMENT PANEL REGISTER ASSEMBLY CENTER


B129890
  1. Attach the 5 clips to install the instrument panel register.



12. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
  1. for HDD:

    1. Install the navigation receiver assembly with bracket (Click here).

  1. for DVD:

    1. Install the navigation receiver assembly with bracket (Click here).



13. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER


B210523
  1. Connect the connector.

  1. Attach the 3 clips and 2 claws to install the cluster finish panel.



14. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER


B210524
  1. Connect the connector.

  1. Attach the 3 clips and 2 claws to install the cluster finish panel.



15. INSTALL COMBINATION METER ASSEMBLY


    B129873
  1. Connect the connector.

  1. Attach the 2 clips to install the combination meter.

  1. Install the 2 screws.



16. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B129872
  1. Attach the 4 clips and 6 claws to install the instrument cluster finish panel.



17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL