DTC P1586 Acceleration Sensor Malfunction |
| DTC Code | DTC Detection Condition
| Trouble Area |
| P1586 |
|
|
|
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P1586) |
Clear the DTCs (Click here).
Perform a road test where the vehicle is driven at 30 km/ h (18 mph) or more, the brakes are applied at least 16 times and the vehicle is finally stopped.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
| Only P1586 is output | A |
| P1586 and other DTCs are output | B |
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (G SENSOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
In accordance with the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| G sensor | Converted output voltage of yaw rate sensor assembly*1 or deceleration sensor*2/ min.: 0 V max.: 5 V | Displays converted voltage of yaw rate sensor assembly*1 or deceleration sensor*2
| - |
| Result | Proceed to |
| Data displayed is as specified under Normal Condition | A |
| Data displayed is not as specified under Normal Condition (w/ VSC) | B |
| Data displayed is not as specified under Normal Condition (w/o VSC) | C |
|
| ||||
|
| ||||
| A | |
| 3.REPLACE BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU) |
Replace the brake actuator assembly (skid control ECU).
| NEXT | |
| 4.PERFORM INITIALIZATION |
| Replaced Part |
|
Using the intelligent tester, perform reset memory, deceleration sensor 0 point calibration and CVT oil pressure calibration (Click here).
Check that no DTC is stored.
| NEXT | ||
| ||
| 5.REPLACE YAW RATE SENSOR ASSEMBLY |
Replace the yaw rate sensor assembly (Click here).
| NEXT | |
| 6.PERFORM INITIALIZATION |
| Replaced Part |
|
Using the intelligent tester, perform reset memory, deceleration sensor 0 point calibration and CVT oil pressure calibration (Click here).
Check that no DTC is stored.
| NEXT | ||
| ||
| 7.REPLACE DECELERATION SENSOR |
Replace the deceleration sensor (Click here).
| NEXT | |
| 8.PERFORM INITIALIZATION |
| Replaced Part |
|
Using the intelligent tester, perform reset memory, deceleration sensor 0 point calibration and CVT oil pressure calibration (Click here).
Check that no DTC is stored.
| NEXT | ||
| ||