DTC P1046 Driver Detects Difference between Target and Actual Valvematic Angle |
DTC P1055 ECM Detects Difference between Target and Actual Valvematic Angle |

| *1 | ECM | *2 | Continuously Variable Valve Lift Controller |
| *3 | EDU | *4 | Actuator |
| *5 | Differential Roller Gear | *6 | Position Sensor and Angle Sensor |
| *7 | Engine | *8 | Continuously Variable Valve Train |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1046 P1055 | The actual duration differs from the requested duration by 22°CA or more for a certain period of time (1 trip detection logic).
|
|
| 1.CHECK ANY OTHER DTCS OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P1046 and/or P1055 is output | A |
| DTC P0112, P0113, P0115, P0117 or P0118 is output at same time as DTC P1046 and/or P1055 | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Remove the continuously variable valve lift controller assembly from the camshaft housing (Click here).
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VALVEMATIC (ENG OFF).
When the continuously variable valve lift controller assembly is operated using the intelligent tester, check whether the shaft moves (Click here).
| Tester Operation | Specified Condition |
| Low | VALVEMATIC Current Angle is 100 to 120°CA and shaft extends |
| High | VALVEMATIC Current Angle is 250°CA and shaft retracts |
|
| ||||
| OK | ||
| ||