DTC P2767 Input / Turbine Speed Sensor "B" Circuit No Signal |
| DTC Code | DTC Detection Condition
| Trouble Area |
| P2767 |
|
|

| 1.READ VALUE USING INTELLIGENT TESTER (SPD (NIN)) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
In accordance with the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SPD (NIN) | Primary pulley speed (NIN)/ min.: 0 rpm max.: 12750 rpm |
| Data is displayed in increments of 50 rpm. |
| Result | Proceed to |
| Data displayed is not as specified under Normal Condition | A |
| Data displayed is as specified under Normal Condition | B |
|
| ||||
| A | |
| 2.INSPECT TRANSMISSION REVOLUTION SENSOR (NIN) |
![]() |
Disconnect the transmission revolution sensor (NIN) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
| *1 | Component without harness connected (Transmission Revolution Sensor (NIN)) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TRANSMISSION REVOLUTION SENSOR (NIN) - ECM) |
![]() |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B32-100 (NIN-) - B32-122 (NIN+) | 20°C (68°F) | 560 to 680 Ω |
| B32-100 (NIN-) - Body ground | Always | 10 kΩ or higher |
| B32-122 (NIN+) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 5.PERFORM INITIALIZATION |
| Replaced Part |
|
Using the intelligent tester, perform reset memory, deceleration sensor 0 point calibration and CVT oil pressure calibration (Click here).
Check that no DTC is stored.
| NEXT | ||
| ||
| 6.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 7.PERFORM INITIALIZATION |
| Replaced Part |
|
Using the intelligent tester, perform reset memory, deceleration sensor 0 point calibration and CVT oil pressure calibration (Click here).
Check that no DTC is stored.
| NEXT | ||
| ||