1.REMOVE BACK DOOR CENTER GARNISH
2.REMOVE BACK DOOR SIDE GARNISH LH
3.REMOVE BACK DOOR SIDE GARNISH RH
Use the same procedure described for the LH side.
4.REMOVE BACK DOOR TRIM BOARD ASSEMBLY
5.REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)
6.REMOVE POWER BACK DOOR SENSOR ASSEMBLY RH (w/ Power Back Door)
Use the same procedure described for the LH side.
7.REMOVE REAR LIGHT ASSEMBLY LH
8.REMOVE REAR LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
9.REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Remove the 4 nuts.
Disconnect the connector.
Detach the 4 clips and remove the back door outside garnish sub-assembly.
10.REMOVE BACK DOOR OPENER SWITCH ASSEMBLY