Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM30B0U _56 Audio / Visual / Telematics _009404 PARK ASSIST / MONITORING _0051188 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AB8  Destination Information Undefined  


DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor has been replaced.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AB8 Destination Information Undefined The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU).
·

CAN communication system

·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (warning cancel switch assembly) is on.


PROCEDURE

1.CHECK DTC (CAN COMMUNICATION SYSTEM)

Result:
Proceed to
CAN communication system DTCs are not output
CAN communication system DTCs are output



CAN communication system DTCs are not output

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

CAN communication system DTCs are output

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
a.

Replace the main body ECU (multiplex network body ECU).

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK DTC
3.CHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314
Result:
Proceed to
No DTC is output
DTC is output from the blind spot monitor sensor LH (Master)
DTC is output from the blind spot monitor sensor RH (Slave)




No DTC is output

END (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] IS DEFECTIVE)

DTC is output from the blind spot monitor sensor LH (Master)

DTC is output from the blind spot monitor sensor RH (Slave)