Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM30B0U _52 Drivetrain _009469 AXLE AND DIFFERENTIAL _0051192 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH

Hide 2.REMOVE FRONT LOWER BALL JOINT ASSEMBLY LH

Hide 3.REMOVE STEERING KNUCKLE LH

a.

Secure the front axle assembly in a vise.

NOTICE:

When using a vise, do not overtighten it.



b.
C163588

Remove the 4 bolts and front axle hub sub-assembly from the steering knuckle.

NOTICE:

Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.



c.

Remove the front brake dust cover from the steering knuckle.