Home › Suspension › FRONT SUSPENSION › FRONT LOWER BALL JOINT
RM30B0U _53 Suspension _009473 FRONT SUSPENSION _0051205 FRONT LOWER BALL JOINT A

FRONT SUSPENSION  FRONT LOWER BALL JOINT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE FRONT AXLE SHAFT NUT LH

Hide 3.DISCONNECT FRONT SPEED SENSOR LH

Hide 4.DISCONNECT FRONT FLEXIBLE HOSE

Hide 5.DISCONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 6.DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

Hide 7.REMOVE FRONT DISC

Hide 8.DISCONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH

Hide 9.REMOVE FRONT AXLE ASSEMBLY LH

Hide 10.REMOVE FRONT LOWER BALL JOINT ASSEMBLY LH

a.

Secure the front axle assembly between aluminum plates in a vise.

NOTICE:

When using a vise, do not overtighten it.



b.

Remove the cotter pin and nut.


c.
C156924
1.302,0.771 1.302,0.26 1.302,0.26 0.74,0.26 false 1.156,0.781 1.156,0.26 false 2.656,0.104 2.927,0.104 2.927,0.104 2.927,0.833 false 2.813,0.833 2.813,0.104 false 0.417,0.167 0.729,0.333 0.313,0.167 10 SST 2.354,0.031 2.667,0.198 0.313,0.167 10 SST 2.667,1.5 2.979,1.656 0.313,0.156 10 *a
*a 1 mm (0.0394 in.)


Install SST to the front lower ball joint as shown in the illustration.

SST
09960-20010  (09961-02050, 09961-02050)

NOTICE:

Make sure that the clearance measurement between SST and the front axle assembly is 1 mm (0.0394 in.).



d.
C278704
2.25,0.646 2.563,0.844 0.313,0.198 10 *a 2.323,0.302 2.635,0.5 0.313,0.198 10 *a 0.135,1.594 0.448,1.792 0.313,0.198 10 *b 2.26,3.49 2.417,3.688 0.156,0.198 10 A 2.26,3.76 2.417,3.958 0.156,0.198 10 B
*a Molybdenum Grease Application Area
*b Turn


Using SST, remove the front lower ball joint from the front axle assembly as shown in the illustration.

SST
09960-20010  (09961-02010, 09961-02050, 09961-02050)

CAUTION:

Apply molybdenum grease to the bolt threads and the tip of SST.


NOTICE:
·

Install SST so that A and B are parallel.

·

Be sure to turn the part indicated in the illustration with a wrench.

·

Do not damage the front lower ball joint dust cover.

·

Be sure to tie the string of SST to the vehicle to prevent SST from dropping.