Home › Suspension › REAR SUSPENSION › REAR COIL SPRING
RM30B0U _53 Suspension _009475 REAR SUSPENSION _0051209 REAR COIL SPRING A

REAR SUSPENSION  REAR COIL SPRING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR UPPER COIL SPRING INSULATOR LH

C276119
3,0.417 3.26,0.604 0.26,0.188 10 *a
*a 10 mm or less


a.

Install the rear upper coil spring insulator to the rear coil spring.

NOTICE:

Install the rear upper coil insulator so that the distance between the stopper and upper end of the rear coil spring is 10 mm (0.394 in.) or less.



Hide 2.INSTALL REAR LOWER COIL SPRING INSULATOR LH

a.

Install the rear lower coil spring insulator to the rear No. 2 suspension arm.


Hide 3.INSTALL REAR COIL SPRING LH

a.
C266194
0.199,2.302 0.466,2.527 0.267,0.225 10 *a 1.354,1.775 0.421,2.386 false 0.421,2.386 1.355,3.148 false
*a Identification Mark


Install the rear coil spring to the rear No. 2 suspension arm.

NOTICE:

Install the rear coil spring so that the identification marks are positioned as shown in the illustration.



b.
C267389

Using a jack and wooden block, raise the vehicle gradually to install the rear No. 2 suspension arm to the rear axle carrier. Then temporarily install the bolt.


Hide 4.TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

Hide 6.TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

a.
C266199

Tighten the bolts of the suspension arm.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)

NOTICE:

Since a stopper nut is used, tighten the bolt.



Hide 7.INSTALL REAR STABILIZER LINK ASSEMBLY LH

Hide 8.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 9.INSPECT AND ADJUST REAR WHEEL ALIGNMENT