Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM › 2012.12–2013.11
RM30B0U _53 Suspension _009985 TIRE / WHEEL _0054776 TIRE AND WHEEL SYSTEM G

TIRE / WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRES

a.

Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:
Tire Size Front
kPa (kgf/cm2, psi)
Rear
kPa (kgf/cm2, psi)
225/65R17 102H 230 (2.3, 33) 230 (2.3, 33)
235/55R18 99H 220 (2.2, 32) 220 (2.2, 32)


Cold Tire Inflation Pressure (for Compact Spare Tire):
Tire Size kPa (kgf/cm2, psi)
T165/80R17 104M 420 (4.2, 60)



b.
C137874

Using a dial indicator, check the runout of the tires.

Tire runout:

1.4 mm (0.0551 in.) or less



Hide 2. ROTATE TIRES

a.
C278926
0.469,0.823 0.781,1.021 0.313,0.198 10 *a 0.479,2.656 0.792,2.854 0.313,0.198 10 *a 0.771,0.177 1.083,0.375 0.313,0.198 10 *A 0.76,2.073 1.073,2.271 0.313,0.198 10 *B
*A w/ Full Size Spare Tire
*B w/o Full Size Spare Tire
*a Front of the Vehicle


Rotate the tires as shown in the illustration.

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)


Hide 3.INSPECT WHEEL BALANCE

a.
C264658
2.098,3.633 2.240,3.803 0.142,0.170 10 A

for Aluminum Wheel Type:

Check and adjust the off-the-car balance.

Maximum imbalance after adjustment:

8.0 g (0.0176 lb.)


NOTICE:
·

Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

·

Do not touch the sticking surface of the tape.

·

Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)


·

Push the balance weight firmly to adhere it to the position.

·

Do not reuse the balance weight.



HINT:
·

The inner side balance weights should be installed by clipping them to the rim.

·

If necessary, check and adjust the on-the-car balance.




b.
C144019

for Steel Wheel Type:

Check and adjust the off-the-car balance.

Maximum imbalance after adjustment:

8.0 g (0.0176 lb.)


HINT:

If necessary, check and adjust the on-the-car balance.



Hide 4.INSPECT FRONT AXLE HUB BEARING LOOSENESS

Hide 6.INSPECT REAR AXLE HUB BEARING LOOSENESS