Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM30B0U _52 Drivetrain _009469 AXLE AND DIFFERENTIAL _0051194 REAR AXLE HUB G

AXLE AND DIFFERENTIAL  REAR AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

Hide 3.REMOVE REAR DISC

Hide 4.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C130656

Using a dial indicator, check for looseness near the center of the axle hub.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the looseness is more than the maximum, replace the axle hub assembly.


Hide 5.INSPECT REAR AXLE HUB RUNOUT

a.
C202386

Using a dial indicator, check for runout on the surface of the axle hub inside the rear axle hub bolt.

Maximum:

for 2WD: 0.08 mm (0.00315 in.)

for AWD: 0.06 mm (0.00236 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the looseness is more than the maximum, replace the axle hub assembly.


Hide 6.INSTALL REAR DISC

Hide 7.CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

Hide 8.INSPECT AND ADJUST PARKING BRAKE

Hide 9.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)