Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM30B0U _58 Vehicle Interior _009988 HEATING / AIR CONDITIONING _0054778 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  B1441/41  Air Mix Damper Control Servo Motor Circuit (Passenger Side)  


DESCRIPTION

The No. 3 air conditioning radiator damper servo sub-assembly (front passenger side air mix) sends pulse signals to indicate the damper position to the air conditioning amplifier assembly. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the No. 3 air conditioning radiator damper servo sub-assembly (front passenger side air mix) to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the output air.

The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
B1441/41 Air Mix Damper Control Servo Motor Circuit (Passenger Side) Air mix damper position sensor value does not change even if air conditioning amplifier assembly operates No. 3 air conditioning radiator damper servo sub-assembly (front passenger side air mix)
·

No. 3 air conditioning radiator damper servo sub-assembly (front passenger side air mix)

·

Air conditioning harness assembly

·

Air conditioning amplifier assembly


Memorized (30 seconds or more) -

HINT:

The air conditioning amplifier assembly stores the DTC of the respective malfunction if it has occurred for the period of time indicated in the brackets.


WIRING DIAGRAM

E269946
5.573,3.115 6.031,3.313 0.458,0.198 10 false z7 3.719,3.302 4.969,3.76 1.25,0.458 10 false Air Conditioning Harness Assembly 5.563,3.302 6.813,3.76 1.25,0.458 10 false Air Conditioning Amplifier Assembly 0.156,3.104 2.094,3.76 1.938,0.656 10 false No. 3 Air Conditioning Radiator Damper Servo Sub-assembly (Front Passenger Side Air Mix) 5.625,0.833 6.083,1.031 0.458,0.198 10 false BUS G 5.385,0.729 5.573,0.927 0.188,0.198 10 false 2 5.635,2.521 6.094,2.719 0.458,0.198 10 false B BUS 5.385,1.563 5.573,1.76 0.188,0.198 10 false 3 5.625,1.698 6.083,1.896 0.458,0.198 10 false BUS 5.375,2.396 5.563,2.594 0.188,0.198 10 false 4

CAUTION / NOTICE / HINT

NOTICE:

When the battery is disconnected, or servo motor or the air conditioning amplifier assembly is replaced, be sure to perform servo motor initialization.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>INITIALIZATION


HINT:

Confirm that no mechanical problem is present because this diagnostic code can be output when either a damper link or the damper is mechanically locked.


PROCEDURE

1.READ VALUE USING TECHSTREAM
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Operate the front passenger side temperature adjustment switch.


e.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


f.

Check the value(s) by referring to the table below.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Air Mix Servo Targ Pulse(P) No. 3 air conditioning radiator damper servo sub-assembly (front passenger side air mix) target pulse Min.: 0
Max.: 255
MAX. COLD: 6 (pulse)
MAX. HOT: 93 (pulse)
-
Body Electrical > Air Conditioner > Data List
Tester Display
Air Mix Servo Targ Pulse(P)
50003 121 71
OK:

The display is as specified in the normal condition column.



Result:
Result Proceed to
OK (When troubleshooting according to the DTC) A
OK (When troubleshooting according to Problem Symptoms Table) B
NG C



A

2.CHECK NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (FRONT PASSENGER SIDE AIR MIX)

B

C

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

2.CHECK NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (FRONT PASSENGER SIDE AIR MIX)
a.

Replace the No. 3 air conditioning radiator damper servo sub-assembly (front passenger side air mix).

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or known good one and check that the condition returns to normal.



b.

Check for DTC.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Proceed to
DTC B1441/41 is not output
DTC B1441/41 is output



DTC B1441/41 is not output

END (NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY [FRONT PASSENGER SIDE AIR MIX] IS DEFECTIVE)

DTC B1441/41 is output

3.CHECK AIR CONDITIONING HARNESS ASSEMBLY
3.CHECK AIR CONDITIONING HARNESS ASSEMBLY
a.

Replace the air conditioning harness assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the air conditioning harness assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning harness assembly with a new or known good one and check that the condition returns to normal.



b.

Check for DTC.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Proceed to
DTC B1441/41 is not output
DTC B1441/41 is output



DTC B1441/41 is not output

END (AIR CONDITIONING HARNESS ASSEMBLY IS DEFECTIVE)

DTC B1441/41 is output

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY