Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM
RM30B0U _51 Engine / Hybrid System _010069 CRUISE CONTROL _0054851 LANE DEPARTURE ALERT SYSTEM J

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  Main Switch Circuit  


DESCRIPTION

The lane departure warning camera receives a lane departure alert main switch signal from the telltale light assembly (lane departure alert main switch).

WIRING DIAGRAM

E226166
2.5,1.417 2.948,1.583 0.448,0.167 10 G43 2.49,1.604 4.052,2.208 1.563,0.604 10 Telltale Light Assembly (Lane Departure Alert Main Switch) 3.708,0.99 3.979,1.156 0.271,0.167 10 6 4.792,2 5.25,2.167 0.458,0.167 10 Q13 5.219,0.99 5.49,1.156 0.271,0.167 10 4 4.813,2.167 6.833,2.448 2.021,0.281 10 Lane Departure Warning Camera 5.417,1.125 5.865,1.292 0.448,0.167 10 LKSW 2.49,0.99 2.667,1.167 0.177,0.177 10 13 2.74,1.01 2.885,1.188 0.146,0.177 10 E 3.333,1 3.792,1.198 0.458,0.198 10 ECU

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELLTALE LIGHT ASSEMBLY [LANE DEPARTURE ALERT MAIN SWITCH] - LANE DEPARTURE WARNING CAMERA AND BODY GROUND)
a.

Disconnect the G43 telltale light assembly (lane departure alert main switch) connector.


b.

Disconnect the Q13 lane departure warning camera connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G43-6 (ECU) - Q13-4 (LKSW) Always Below 1 Ω
G43-6 (ECU) - Body ground Always 10 kΩ or higher
G43-13 (E) - Body ground Always Below 1 Ω


Result:
Proceed to
OK
NG




OK

2.INSPECT TELLTALE LIGHT ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT TELLTALE LIGHT ASSEMBLY
a.

b.

Inspect the telltale light assembly.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SWITCH>INSPECTION

Result:
Proceed to
OK
NG




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG