This circuit detects whether the ignition switch is ACC or off, and sends this information to the main body ECU (Multiplex Network Body ECU).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Using the Techstream, read the Data List.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ACC SW | Ignition switch ACC signal | ON or OFF | ON: Ignition switch ACC
OFF: Ignition switch off |
"ON" is also displayed for this item when the ignition switch is ON. |
| Tester Display |
|---|
| ACC SW |
The display is as specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Instrument Panel Junction Block Assembly) |
Disconnect the instrument panel junction block assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3A-1 - Body ground | Always | 11 to 14 V |
| 3C-45 - Body ground | Ignition switch ACC | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3D-9 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
Remove the instrument panel junction block assembly connectors.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Reconnect the 3A, 3C and 3D instrument panel junction block assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A-29 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG