The main body ECU (Multiplex Network Body ECU) detects the condition of the parking brake switch.
Using the Techstream, read the Data List.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Parking Brake SW | Parking brake switch signal | ON or OFF | ON: Parking brake switch on
OFF: Parking brake switch off |
- |
| Tester Display |
|---|
| Parking Brake SW |
The display is as specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the parking brake switch assembly.
Inspect the parking brake switch assembly.
Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G37 parking brake switch assembly connector.
Disconnect the 3D instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-1 - 3D-34 | Always | Below 1 Ω |
| G37-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-12 (PKB) - 3D-34 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG