Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM
RM30B0U _59 Vehicle Exterior _010071 LIGHTING (EXT) _0054854 AUTOMATIC HIGH BEAM SYSTEM C

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  B124B  Automatic High Beam System  


DESCRIPTION

This DTC is stored when the main body ECU (multiplex network body ECU) detects malfunction in the automatic high beam system.

When DTCs for the following systems are stored, this DTC is stored simultaneously.

·

Lane departure alert system malfunction

·

CAN communication system malfunction


DTC No. Detection Item DTC Detection Condition Trouble Area
B124B Automatic High Beam System Malfunction in automatic high beam system
·

Lane departure alert system

·

CAN communication system

·

Main body ECU (multiplex network body ECU)



WIRING DIAGRAM

E270527
0.594,0.771 2.75,1.188 2.156,0.417 10 Main Body ECU (Multiplex Network Body ECU) 4.365,0.844 6.375,1.156 2.01,0.313 10 Lane Departure Warning Camera 0.573,2.302 2.583,2.5 2.01,0.198 10 : CAN Communication Line


CAUTION / NOTICE / HINT

NOTICE:
·

First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this DTC.

·

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT



PROCEDURE

1.CHECK FOR DTC (AUTOMATIC HIGH BEAM SYSTEM)
a.

Clear the DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Clear DTCs
50002 123

b.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Proceed to
DTC B124B is not output
DTC B124B is output



DTC B124B is not output

DTC B124B is output

2.CHECK FOR DTC (ALL)
2.CHECK FOR DTC (ALL)
a.

Connect the Techstream to DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: System Select / Health Check.


d.

Check for DTCs.


Result:
Proceed to
Lane departure alert system DTCs are not output
Lane departure alert system DTCs are output
CAN communication system DTCs are output



Lane departure alert system DTCs are not output

3.CHECK LANE DEPARTURE WARNING CAMERA

Lane departure alert system DTCs are output

CAN communication system DTCs are output

3.CHECK LANE DEPARTURE WARNING CAMERA
a.

Temporarily replace the lane departure warning camera with a new or normally functioning one.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>REMOVAL


b.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Proceed to
DTC B124B is not output
DTC B124B is output



DTC B124B is not output

END (LANE DEPARTURE WARNING CAMERA WAS DEFECTIVE)

DTC B124B is output

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)