Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU
RM30B0U _55 Steering _010121 POWER ASSIST SYSTEMS _0054953 POWER STEERING ECU A

POWER ASSIST SYSTEMS  POWER STEERING ECU  INSTALLATION  


PROCEDURE

Hide 1.INSTALL POWER STEERING ECU ASSEMBLY

a.

Install the power steering ECU assembly with the new 2 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Install the 3 new terminal bolts.

Torque:
3.2 N*m (33 kgf*cm, 28 in.*lbf)


c.

Install the 2 new power steering ECU protectors to the power steering ECU assembly.


d.

Install a new ECU wire sub-assembly to the power steering ECU assembly.


Hide 2.INSTALL ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).