1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.REMOVE HEADLIGHT
3.REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY
4.REMOVE RADIATOR UPPER AIR GUIDE PLATE
5.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the discharge hose sub-assembly from the cooler condenser assembly.
Remove the O-ring from the discharge hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
6.DISCONNECT LIQUID PIPE SUB-ASSEMBLY
Remove the bolt and disconnect the liquid pipe sub-assembly from the cooler condenser assembly.
Remove the O-ring from the liquid pipe sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
7.REMOVE NO. 1 RADIATOR SUPPORT
8.REMOVE NO. 2 FAN SHROUD
Detach the 3 clamps and disconnect the water by-pass pipe from the No. 2 fan shroud.
Remove the 2 bolts and No. 2 fan shroud.
9.REMOVE COOLER CONDENSER ASSEMBLY
Detach the 2 guides and remove the cooler condenser assembly as shown in the illustration.
Do not damage the cooler condenser or radiator when removing the cooler condenser assembly.