1.DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
2.REMOVE HEADLIGHT
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
5.REMOVE BATTERY CLAMP SUB-ASSEMBLY
6.REMOVE HOOD LOCK ASSEMBLY
7.DISCONNECT HOOD LOCK CONTROL CABLE ASSEMBLY
Detach the clamp to disconnect the hood lock contorl cable assembly from the upper radiator support.
8.REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY
Disconnect the horn connector.
Remove the 3 bolts and front bumper upper reinforcement sub-assembly.
9.REMOVE RADIATOR UPPER AIR GUIDE PLATE
Remove the 7 clips and radiator upper air guide plate.
10.DISCONNECT LIQUID PIPE SUB-ASSEMBLY
11.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
12.DISCONNECT WIRE HARNESS
| *a | w/o Hood Courtesy Switch |
Disconnect the 2 cooling fan motor connectors.
Detach the 9 wire harness clamps to disconnect the wire harness.
13.REMOVE NO. 1 RADIATOR SUPPORT
Remove the 2 bolts and 2 No. 1 radiator supports.
14.REMOVE UPPER RADIATOR SUPPORT
Remove the 4 bolts and upper radiator support.
15.REMOVE RADIATOR HOSE HOSE CLAMP
| *a | Push |
Disconnect the No. 8 and No. 9 water by-pass hose from each radiator hose hose clamp.
Remove the 2 radiator hose hose clamps.
16.DISCONNECT RADIATOR HOSE SUB-ASSEMBLY
Slide the hose clamp and disconnect the radiator hose sub-assembly from the cylinder head sub-assembly.
17.DISCONNECT NO. 2 RADIATOR HOSE
18.DISCONNECT NO. 1 WATER BY-PASS HOSE
Slide the hose clamp and disconnect the No. 1 water by-pass hose from the water by-pass pipe.
19.DISCONNECT NO. 2 WATER BY-PASS HOSE
Slide the hose clamp and disconnect the No. 2 water by-pass hose from the radiator assembly.
20.REMOVE RADIATOR ASSEMBLY
Remove the radiator assembly together with the fan shroud.
After removing the radiator assembly, make sure that both lower radiator supports are attached to the fan shroud.
21.REMOVE RADIATOR HOSE SUB-ASSEMBLY
Slide the 2 hose clamps and remove the radiator hose sub-assembly from the radiator assembly and water by-pass pipe.
22.REMOVE NO. 2 RADIATOR HOSE
Slide the hose clamp and remove the No. 2 radiator hose from the radiator assembly.
23.REMOVE WATER BY-PASS PIPE
Detach the 3 clamps, slide the hose clamp and remove the water by-pass pipe from the radiator assembly.
24.REMOVE LOWER RADIATOR SUPPORT
Remove the 2 lower radiator supports from the fan shroud.
25.REMOVE NO. 2 FAN SHROUD
Remove the 2 bolts.
Detach the 2 claws and remove the No. 2 fan shroud.
26.REMOVE COOLER CONDENSER ASSEMBLY
Detach the 2 guides and reode the cooler condenser assembly.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>CONDENSER>REMOVAL
27.REMOVE FAN SHROUD
Remove the 2 bolts and fan shroud.