Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU
RM30B0U _58 Vehicle Interior _010074 SUPPLEMENTAL RESTRAINT SYSTEMS _0054974 OCCUPANT CLASSIFICATION ECU A

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION ECU  INSTALLATION  


PROCEDURE

Hide 1.INSTALL OCCUPANT DETECTION ECU

a.
B341153

Attach the claw to install the occupant classification ECU.

NOTICE:

If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.



b.

Connect the 2 connectors.

NOTICE:

When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.



Hide 2.INSTALL FRONT SEAT ASSEMBLY RH

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION