Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat)
RM30B0U _58 Vehicle Interior _010074 SUPPLEMENTAL RESTRAINT SYSTEMS _0055016 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

·

If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.



HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH

a.

Install the front seat airbag assembly LH with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

CAUTION:
·

The nuts must not be reused.

·

Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.




b.

Attach the 2 clamps to the front seatback frame sub-assembly.


Hide 2.INSTALL SEPARATE TYPE FRONT SEATBACK PAD

Hide 3.INSTALL SEPARATE TYPE FRONT SEATBACK COVER

Hide 4.INSTALL FRONT SEAT HEADREST SUPPORT

Hide 5.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 6.INSTALL FRONT INNER SEAT CUSHION SHIELD LH

Hide 7.INSTALL FRONT SEAT CUSHION SHIELD LH

Hide 8.INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION