Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL
RM30B0U _54 Brake _010843 BRAKE SYSTEM (OTHER) _0057926 BRAKE PEDAL A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Install the brake pedal support assembly with the 4 nuts.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


b.

Install the brake pedal support reinforcement set bolt.

Torque:
23.6 N*m (241 kgf*cm, 17 ft.*lbf)


Hide 2.INSTALL PUSH ROD PIN

a.
C281272
1.271,2.99 1.656,3.073 0.385,0.083 10 false .
V100135

Lithium sop base glycol grease


Apply a light coat of lithium soap base glycol grease to the push rod pin.


b.

Set the push rod clevis in place, insert the push rod pin from outside the vehicle and then a new clip.

NOTICE:

After installation, check that the pedal operates smoothly.



Hide 3.INSTALL BRAKE PEDAL RETURN SPRING

a.

Install the brake pedal return spring to the brake pedal support assembly.


Hide 4.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 5.CONNECT CONNECTORS

a.

Connect the brake pedal load sensing switch connector.


b.

Connect the stop light switch connector.


Hide 7.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 9.CHECK AND ADJUST BRAKE PEDAL