Use the following procedures to troubleshoot the steering lock system.
*: Use the Techstream.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer and confirm the problem.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>PRECAUTION
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
A simple method to determine whether the battery is depleted is to operate the horn.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and make a note of any codes that are output.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DTC CHECK / CLEAR
When DTCs indicating CAN and/or LIN communication system malfunctions are output, repair the CAN and/or LIN communication systems before performing diagnosis.
for CAN: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
for LIN: Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| DTC is not output. (Problem symptom cannot be confirmed or reproduced.) | A |
| DTC is not output. (Problem symptom can be confirmed and reproduced.) | B |
| Steering lock system DTC is output. | C |
When steering lock system DTCs are output, refer to Diagnostic Trouble Code Chart.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
The steering lock system does not store past DTCs.
A
B
C
Proceed to How to Proceed with Troubleshooting.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Proceed to Problem Symptoms Table.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| Fault is not listed in Problem Symptoms Table. |
| Fault is listed in Problem Symptoms Table. |
Fault is not listed in Problem Symptoms Table.
Fault is listed in Problem Symptoms Table.
Proceed to Data List / Active Test.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DATA LIST / ACTIVE TEST
Proceed to Terminals of ECU.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DTC CHECK / CLEAR
Check for DTCs and make a note of any codes that are output.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DTC CHECK / CLEAR
Perform the DTC output confirmation operation.
| Proceed to |
|---|
| DTC is not output. |
| Steering lock system DTC is output. |
DTC is not output.
Steering lock system DTC is output.