Use these procedures to troubleshoot the LIN communication system.
*: Use the Techstream.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the Techstream, inspect the CAN communication function to ensure that there are no malfunctions in the communication system.
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Using the Techstream, inspect the LIN communication function to ensure that there are no malfunctions in the communication system.
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
Data List / Active Test
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT